EverFocus Flex1.0 Bedienungsanleitung PDF herunterladen (Seite 69)

EverFocus Navigation Access Control Management Software

5) Select a time section on the left to change the access mode preset.

6) Return after addition.

After setting of door schedule of door, click the “Save” button to save the settings of door

schedule of door.

4.2.4.5 Apply to other date

When a date schedule setting is completed and other date schedule setting is the same, click

the “Apply to other date” button

in the operating bar of date type set in the door schedule

setting page, then the page of date selection dialog box below pops up:

Operating procedure:

1) Select the date type set on the door schedule setting page.

2) Click the “Apply to other date” button in the operating bar.

3) Select the date type to be set (one, several or all).

4) Click the “Confirm” button to modify and display the corresponding date time section on the

door schedule setting page.

!Note: after verification setting of door schedule, click “save” button to save the modified

information.

4.2.5 Door setting

Door setting means an overall setting of access rules for all controllers and all door in the

ACCESS SYSTEM. The rules used in door setting are just the settings in the door schedule

described in the section above. The access rules of Flex1.0 controller are set here, but Flex II is

not set here unless the access group designates the controller to use the door setting.

Click “Access Rule”  “Access Management” menu, select “Door Setting” to enter into the page

of door setting, as shown in the figure below:

Operating procedure:

1) Select proper door schedule for each door.

2) After setup of door schedule for all doors, click the “Confirm” button, then the prompt box

pops up on the page:

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 139 140

Keine Kommentare

EverFocus Flex1.0 Bedienungsanleitung Seite 69