EverFocus EBC890 Bedienungsanleitung PDF herunterladen (Seite 50)

4242

Fire alarm, zone alarm 1~4, unknown user, expired user, invalid user, user PIN fail, invalid time

zone, system PIN fail, ARM PIN fail, door forced open, door held open, and remote alarm.

All these events can be allocated to any alarm output. Note the built-in buzzer will beep

when any alarm output is triggered for any reason. The detailed configuration method is

introduced in the following section.

Enter Alarm Setting Menu

Under System menu, press three times to bring up the following window:

Press to enter Alarm Setting menu. Use and to choose from different menu

options. All menu options under Alarm Setting are introduced below:

Fire Alarm

For correspondence between fire alarm and doors, please refer to “Set Door Control at Fire

Alarm” in this chapter. In case of fire alarm input, controller will generate fire alarm output

according to this setting. By default, both alarm outputs are active per Fire Alarm event. At the

following submenu:

Press the 1-2 numeric key to toggle between Y/N for corresponding alarm output. Y means

the alarm output in enabled. N means the alarm output is disabled.

Note: The above procedure to set Y/N for alarm outputs are the same for the rest of

the following submenus.

SYS PIN Fail

Please refer to section “Set System P” in this chapter to know how to set system PIN. A SYS

PIN Fail event will be generated when user enters the PIN to enter system setting and a wrong

PIN is entered three times consecutively.

Use steps outlined in “Fire Alarm” submenu to change settings.

SYS PIN Fail

SYS PIN FailSYS PIN Fail

SYS PIN Fail

NNNN

Fire Alarm

Fire AlarmFire Alarm

Fire Alarm

YYYY

Alarm Setting

Alarm SettingAlarm Setting

Alarm Setting

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 63 64

Keine Kommentare

EverFocus EBC890 Bedienungsanleitung Seite 50