EverFocus eDR400 Wartungshandbuch PDF herunterladen (Seite 10)

EverFocus Electronics

Installation and start-up

Location and connection

Attention!

PowerCon Station was designed for indoor use. Choose a location ensuring

that the machine is exposed neither to extreme temperatures nor to extreme

humidity. The ambient temperature must be between 5 and 40° C, the

humidity may not exceed 90%.

• PowerCon Station mustn’t be located near to heating elements or other heat sources.

Avoid a position with direct sunlight affection.

• Make sure that no liquids or articles will penetrate the device.

• Take care of sufficient cooling of the device

• To minimize electrical interferences, only delivered or suitable cables should be used.

• Place all cables in such way that they will not be damaged and take care of strain relief.

• Prior to connecting further devices (e.g. monitor or printer), consider these devices’

documentations where important information about environment, location and

installation are given.

Peripheral devices

• Connect the supplied keyboard and mouse to the two round sockets at the PowerCon

Station rear panel. Pay attention to the sockets’ marks.

• Connect a computer monitor to the monitor socket via a suitable cable.

• If requested, connect a printer to the PowerCon Station’s parallel port via a parallel

printer cable.

• Connect PowerCon Station to the network via a UTP Cat 5 network cable and an RJ45

connector.

• If requested, connect PowerCon Station to the telephone net via the ISDN socket.

Power connection

Attention!

Prior to connecting the power cable, verify the accurate position of the

power switch underneath the power connection socket. The power indicated

on the switch must correspond to the location’s voltage.

• On finishing all further connections, place the power cable into the power connection

socket and connect it to a secured power socket.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

EverFocus eDR400 Wartungshandbuch Seite 10