EverFocus EverPlex 8 C Q Bedienungsanleitung PDF herunterladen (Seite 17)

3.1. The pin assignment of the 9 pin D-SUB connector

PIN # NAME PIN # NAME

1 NOT CONNECTED 1 NOT CONNECTED

2 TXD 2 RXD

3 RXD 3 TXD

4 NOT CONNECTED 4 DTR

5 GROUND 5 GROUND

6 NOT CONNECTED 6 DSR

7 NOT CONNECTED 7 RTS

8 NOT CONNECTED 8 CTS

9 NOT CONNECTED 9 NOT CONNECTED

EverPlex 8CQ

HOST

3.2. Transmission Setting

The transmission setting in EverPlex 8CQ is 9600 baud rate, 1 start bit, 1 stop bit and no parity

3.3. Remote control protocol

A computer or a terminal can be used to control the EverPlex 8CQ by sending two-character

ASCII command through RS232 connector, these ASCII commands are started with 'K' or 'k'.

there are 9 ASCII commands mapped to the 9 keypads in the front panel and 1 additional

commands to reset the EverPlex 8CQ to the QUAD A display state. these 10 ASCII commands are:

EverPlex 8CQ Remote Control Command Table

ASCII CODE FUNCTION Keypad in front panel

K1 Full Screen 1

K2 Full Screen 2

K3 Full Screen 3

K4 Full Screen 4

K5 PAGE A A

K6 PAGE B B

K7 Sequential Switching SEQ

K8 VCR Play Back

K9 SET SET

K0 Reset EverPlex 8CQ to Quad display none

EverFocus Electronics Corp.

1 2 ... 12 13 14 15 16 17 18 19

Keine Kommentare

EverFocus EverPlex 8 C Q Bedienungsanleitung Seite 17